Comtech EF Data CDM-840 - Manual (Page 118)

CDM-840 Remote Router Revision 2
Ethernet-based Remote Product Management MN-CDM840
6–50
Add New Route
Use this section to directly add a Route Table entry. From left to right:
Column Description
Index This is the read-only internal table index. It cannot be edited.
Description Enter a l abel string in this text box. T his label helps to maintain the network. T he
assigned name must be unique and cannot contain any whitespace.
Dest. IP/Mask Enter a Destination IP Address/Mask in the form XXX.XXX.XXX.XXX/YY.
Interf. Use the drop-down list to select the Interface as toWAN or toLAN.
Next Hop IP Enter the desired Next Hop I P Address for toLAN routes. Note that no N ext Hop
entry is needed for toWAN routes.
Header Comp. Use the drop-down list to Disable or Enable Header Compression operation.
Payload Comp. Use the drop-down list to Disable or Enable Payload Compression operation.
Enter the desired information. Click [Add Entry] when done. The index automatically increments
to the next available number when the new route is added.
When in Router Mode, the CDM-840 will not transmit a multicast address in the
Internet control range (224.0.0.0 to 224.0.1.255). It filters the packets.
Delete Route
Enter Route Index to Delete. This deletes the specified route entry from the route table. Click
[Delete Entry] when done.
Route Table (Edit)
Use the text boxes and drop-down lists to edit all current Route Table entries, as described
previously for the Add New Route section.
Click [Submit Changes] to save.