Comtech EF Data CDM-840 - Manual (Page 86)

CDM-840 Remote Router Revision 2
Ethernet-based Remote Product Management MN-CDM840
6–18
6.4.4.5 Configuration Pages
1.
The BUC and LNB tabs are functional ONLY when those optional products are
installed.
2.
Precision Time Protocol is not available in this firmware release. The PTP tab,
while available and selectable on this interface, is therefore non-functional.
Use the nested Configuration pages to configure all unit parameters. Dependent on availability,
first click the Configuration tab, and then select the Interface, WAN, Network, ECM, or dSCPC
tab to continue.
6.4.4.5.1 Configuration | Interface Pages
Click the Configuration | Interface tabs, and then select the FE-Mgt, GE, or E1 tab to continue.
6.4.4.5.1.1 Configuration | Interface | FE-Mgt
1. The IP Addresses for the FE and GigE Interfaces must be different and on
separate subnets.
2. The FE Management port will always be in Router Mode. The Traffic Port will
change from Router Mode to BPM Mode when the Working Mode is changed.
Use this page to configure the rear panel ‘MANAGEMENT | FE’ (10/100 BaseT Fast Ethernet)
M&C port. Note that this port serves as the dedicated Ethernet-based monitor and control
interface between the CDM-840 and the user PC.
Figure 6-9. Configuration | Interface | FE-Mgt Page