Comtech EF Data CDM-840 - Manual (Page 169)

CDM-840 Remote Router Revision 2
Serial-based Remote Product Management MN-CDM840
7–23
Parameter
Type
Command
(Instruction
Code
& Qualifier)
Number of
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code &
Qualifier)
Response to Query
(Target to Controller)
SNMP
Unit Name
SSN= 16 bytes Command or Query.
Sets or returns the SNMP System Name string
Example: <1/SSN=Remote1.
Note: If not configured it returns empty string
SSN =
SSN!
SSN? SSN =x [1..16]
(see Description of
Arguments)
Serial
Number
N/A 9 bytes Query only.
Returns the 9-digit serial number.
Example: <1/SNO?’cr’
N/A SNO? SNO=xxxxxxxxx
(see Description of
Arguments)
Adjustment
for Internal
10MHz High-
stability
Reference
ADJ= 4 bytes Command or Query.
Sets or returns the fine adjustment of the Internal 10MHz Reference on the
High-Stability Frequency Reference module in the form sddd, where:
s= sign [– (negative) or + (positive)]
ddd= value, 0-999.
Example: <1/ADJ=-123’cr’
ADJ=
ADJ?
ADJ*
ADJ#
ADJ? ADJ=sddd
(see Description of
Arguments)
Circuit ID
String
CID= 4 to 32 bytes Command or Query.
Sets or returns the user-defined Circuit ID string, which is 4 to 32 characters in
length. Valid characters include:
Space ( ) * + – , . / 0 9 and A thru Z
Example: <1/CID=RxCircuitID’cr’
CID=
CID?
CID*
CID#
CID? CID=x [4..32]
(see Description of
Arguments)
Unit Test
Mode
TST= 1 byte Command or Query.
Sets or returns Unit Test Mode in the form x, where:
0=Normal Mode (no test)
1=Tx CW
2=Tx Alternating 1,0 Pattern
3 = QPSK PN Pattern
Example: <1/TST=1’cr’
TST=
TST?
TST*
TST#
TST? TST=x
(see Description of
Arguments)
Traffic IP IG1= 18 bytes Command or Query.
Sets or returns the IP address and network prefix for the 10/100 BaseT
Ethernet Traffic port, in the form xxx.xxx.xxx.xxx/yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Example: <1/IG1=192.168.001.004/24’cr’
IG1=
IG1?
IG1*
IG1#
IG1? IG1= xx.xxx.xxx.xxx/yy (See
description of arguments)