Fluke Biomedical ProSim 6 - Manual (Page 63)

Vital Signs Simulator
Non-Invasive Blood Pressure Simulation and Tests
51
Push the Stop softkey to stop the test. This will cause a Vent softkey to show in the
display. The pressure will remain at the level it was when the Stop softkey was pushed.
Either push the Vent softkey to vent the pressure system or change the pressure and push
the Start softkey to do another test.
How to Check a Manometer
The manometer function sets the Product up as a pressure gauge to measure pressure
supplied by an external source.
To measure pressure:
1. Connect the pressure port to a pneumatic system as shown in Figure 44.
ProSim 8
Squeeze
Pressure Pump
Blood Pressure
Gauge
glh050.eps
Figure 44. Manometer Connections
2. From the NIBP screen, push the Tests softkey.
3. Push  or  to highlight Manometer.
4. Push .
The digital pressure screen in Figure 45 is shown in the display.
glh011.bmp
Figure 45. Manometer Screen
As the external generator increases the pressure, the digital and analog pressure values in
the display shows the current pressure.