Hypertherm HD4070 Rev.1 - Manual (Page 134)

OPERATION
HyPerformance HD4070 Instruction Manual 4-9
BACK
6
TORCH
1
SELECT THICKNESS
RANGE
BACK
1/4 IN
1/4 - 1 IN
MARKING
SELECT
THICKNESS
BACK
1/4 IN
1/2 IN
7/16 IN
3/8 IN
5/16 IN
9/16 IN
1 IN
7/8 IN
3/4 IN
5/8 IN
Indicates last button selected.
9
8
TORCH
2
SELECT
MATERIAL
BACK
MILD STEEL
STAINLESS STEEL
ALUMINUM
7
System setup screens – continued
3
Select which torch is to be used. This screen will be
bypassed if the 2-torch option is not installed.
Note: When a two torch system is in single torch
mode. A torch receptacle plug must be
installed in the torch that is not being used.
Select the material to be cut.
Select material thickness range.
Select material thickness.
After pressing the desired thickness,
the display will advance to screen 10.