NavCom StarUtil Rev.E - Manual (Page 31)

STARUTIL User Guide Rev. E
Base & Rover pair for optimal performance, and also requires an external RTK link be established.
RTK Extend is only available in NavCom Technology receivers that are StarFire™ capable. To learn
more about RTK Extend follow this link:
http://www.navcomtech.com/products/rtkextend.cfm
To enable RTK Extend in the Rover receiver, go to the Rover Navigation & Tracking window shown
in Figure 15; in the RTK Corrections Format area click the “USE” button adjacent to RTK (5B, 5C,
5E). Then click the “USE” button adjacent to RTG Input. Click “Apply” and then “Retrieve” to ensure
your choices have been saved at the receiver.
Ensure that an input port for your RTK Extend corrections has been established in the Unit Ports
Configuration window as shown in Figure 30.
Once the corrections have been successfully received and applied, the resulting RTK Extend
Navigation indicators can be viewed in the dGPS Mode area of the B1 Solution display shown in
Figure 18.
NCT RTK Input
‡
This example assumes the receiver has been setup in compliance with Chapters 2 & 3, and a
correction source has been established in compliance with Chapter 4.
Go to the Rover Navigation & Tracking window shown in Figure 15; in the RTK Corrections Format
area click the “USE” button adjacent to RTK (5B, 5C, 5E). Click “Apply” and then “Retrieve” to
ensure your choices have been saved at the receiver.
Ensure that an input port for your corrections has been established in the Unit Ports Configuration
window as shown in Figure 30.
Once the corrections have been successfully received and applied, the resulting RTK Navigation
indicators can be viewed in the dGPS Mode area of the B1 Solution display shown in Figure 18.
RTCM RTK Input
‡
This example assumes the receiver has been setup in compliance with Chapters 2 & 3, and a
correction source has been established in compliance with Chapter 4.
Go to the Rover Navigation & Tracking window shown in Figure 15; in the RTK Corrections Format
area click the “USE” button adjacent to RTCM RTK. Click “Apply” and then “Retrieve” to ensure
your choices have been saved at the receiver.
Ensure that an input port for your corrections has been established in the Unit Ports Configuration
window as shown in Figure 30.
Once the corrections have been successfully received and applied, the resulting RTK Navigation
indicators can be viewed in the dGPS Mode area of the B1 Solution display shown in Figure 18.
CMR+/CMR RTK Input
‡
This example assumes the receiver has been setup in compliance with Chapters 2 & 3, and a
correction source has been established in compliance with Chapter 4.
5 – 28