NavCom StarUtil Rev.E - Manual (Page 50)

STARUTIL User Guide Rev. E
Chapter 11 Tools Menu
The Tools menu is an area of StarUtil where the user will upload new firmware, StarFire™ licenses,
and Receiver Options. This is also where the NMEA Viewer and MMC Internal Data logging menu
items discussed in previous chapters are located. In this chapter we will concentrate on those items
that have not been previously mentioned. Figure 61 shows the sub menus under the TOOLS menu
item.
Figure 61: Tools Commands
Power Management
This feature allows the user to configure the unit’s power up status. Clicking on Power Management
brings up the window shown in Figure 62. There are three choices available:
¾ I/O Switch: In this position the power On/Off status is controlled exclusively via the front
panel On/Off button.
¾ On With Power: With this radio button chosen, the unit will automatically power up when
DC voltage is sensed at the input circuitry.
¾ Sensor’s Last State: When enabled, this mode will remember the last MANUAL state of the
ON/OFF button when power is removed via the input source.
Figure 62: Power Management Control Window
11 - 47