Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 122)

3-92 W A N s u i t e 5 1 6 5
NOTICE: Remember that passwords are case-sensitive and are limited to no more
than 10 characters. When logging on, password must be entered exactly
as it was programmed.
Log Out
The Log Out screen (Figure 3.94) is used to log the current user off of the
Web Server. The Log Out function is only available after user password
protection has been set. You will be logged out of the system automatically
1 hour after you user log on using a password to gain access; after this, you
will be required to enter the password to gain write access.
Figure 3.94 Log Out Screen
In-band Management
There are two ways to implement remote in-band management of a
WANsuite 5165 unit. The first is to use the local router to route management
frames (Web browser or SNMP) between the local LAN and the remote unit.
The second is to use the local WANsuite 5165 unit as an independent
gateway.
Use of Connected Local Router
If you choose this method, no configuration is required in the WANsuite
5165s. Local Router A will route Web/SNMP frames from the PC to the
remote WANsuite 5165s. The remote WANsuite 5165 IP address must be set
within the same network as the remote routers B and C LAN network.
Figure 3.95 Frame Relay Network
If the remote units are required to have an IP address for Networks that are
different from the remote routers, a static route will have to be configured in
PC
Router
A
FSM
FSM
FSM
Router
C
Router
B
WAN SUITE
5165
WAN SUITE
5165
WAN SUITE
5165