Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 31)

W e b S e r v e r I n t e r f a c e 3-1
C H A P T E R
3
C HAPTER 3
W
EB
S
ERVER
I
NTERFACE
The WANsuite 5165 has an innovative, embedded Web-based user interface
(WANsight) for remote configuration and real-time reporting via Microsoft
Internet Explorer 5.0 or higher. Access to the Web server interface and how
the interface is used to configure the WANsuite 5165 unit are described in
detail below.
NOTICE: Verilink recommends the use of Microsoft’s Internet Explorer 5.0 or
higher because if you use other Internet browsers to access the Web
server interface, some screen elements will not display as described in
this manual.
NOTICE: The material presented in this chapter follows the order listed in the
navigation bar on the left side of the Web Server interface screen.
However, because the parameters you specify in the Service Table
attach protocols to interfaces, you must configure the Service Table
first. (See "Services Screen" on page 3-18.) You will not be able to
allocate channels (see "DS0 Monitor Details Screen" on page 3-22)
until the Service Table has been configured.
Configuration through the VT100 interface is covered in Chapter 4.
Accessing the Web Server Interface
You can access the Web Server interface by connecting to its IP address. This
connection can be directly through the 10/100 Ethernet port, in-band via PPP
over any port, or in-band via encapsulated IP traffic on the Frame Relay
circuit.
NOTICE: Any changes to the unit’s configuration MUST be followed by a
“Submit” if there is a “Submit” key on the menu. If you change the
Service Table, you must perform a “Save and Restart.”