Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 59)

W e b S e r v e r I n t e r f a c e 3-29
NOTICE: If either side of the Frame Relay connection goes down, you will be
unable to remotely access any connected units.
FrameStart Auto
Discovery
When this parameter is set to “Yes,” the unit will send FrameStart discovery
and delay frames to each DLCI it learns as soon as the DLCIs are set active.
This is required to calculate round-trip delay as well as to discover remote
WANsuite units. This parameter should be set to “Yes” only on network
services that have a WANsuite unit(s) at the far end of the frame relay
connection. Also, if set to “Yes,” the unit will gather SLA parameters such as
frame and data delivery ratio as defined in the Frame Relay Forum
Implementation, FRF.13. Those gathered statistics are then displayed on the
DLCI Statistics Screen on page 3-47.
Values: No, Yes
Default: No
Round Trip Delay Size Specifies the frame size (in bytes) to use when sending Round Trip Delay
packets.
Round Trip Delay Rate Specifies the rate (in seconds) at which Round Trip Delay packets are sent.
Status and Alarms Table
The table displayed at the bottom of the Frame Relay Service Details screen
reports on the status and condition of LMI parameters and on Receive/
Transmit alarms and thresholds. Alarm threshold levels may be changed by
entering a new threshold value in the appropriate field of the table and
clicking the “Submit” button. Table fields are describe below.
Active Read-only field shows whether or not (No or Yes) an alarm is active.
LMI Type Read-only status indicates ANSI, CCITT, LMI rev. 1, or Unknown.
FrameStart Status Read-only status indicates Sourcing, Monitoring, or 0.
Rx Invalid Threshold Number of invalid frames received during a 15-minute interval after which an
invalid alarm will be triggered. Default of “0” disables this alarm.
Rx Invalid Alarm Status of this alarm indicates OK or Alarmed.
Tx Threshold Number of bits per second sent during a 15-minute interval after which a Tx
alarm will be triggered. Default of 0 disables this alarm.
Tx Alarm Status of this alarm indicates OK or Alarmed.
Rx Threshold Number of bits per second sent during a 15-minute interval after which an Rx
alarm will be triggered. Default of 0 disables this alarm.
Rx Alarm Status of this alarm indicates OK or Alarmed.