Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 51)

W e b S e r v e r I n t e r f a c e 3-21
Service Details Screen
Clicking on an index number under the “Service Index” column on the
Services screen will display a Service Details screen such as the one shown
below (Figure 3.19). (In this example, the selected service type is Frame
Relay.)
Figure 3.19 Service Details Screen
The Service Details screen lets you change for each service the parameters
listed below.
* PPP is the only service that may be attached to the Virtual interface. You would choose the
Virtual interface for PPP if you elected to run PPP over Frame Relay. When you attach PPP to
the Virtual interface, you must supply an endpoint over which to send PPP encapsulated data,
and that endpoint must be for a Frame Relay DLCI.
In addition, the Service Details screen provides the following user-activated
buttons:
Parameter Options
Interface Unassigned, Supervisory, Network 1, Network 2, Serial 1, Serial 2,
10/100 Ethernet, Virtual*
Type TDM, PPP, Frame Relay, SCADA, IP, tty
Pair User-assigned integer field that specifies where to route the traffic
from this Service. If the Service is terminated by the unit, set this
value to “0” (zero).
Button Function
Submit Sets any values that have been changed.
Interface Details Opens the Details screen for the Interface of the currently selected
service.
Type Details Opens the Details screen for the Type of the currently selected
service.
Delete Service Opens the Verify Delete Service screen.