Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 72)

3-42 W A N s u i t e 5 1 6 5
Backup Endpoint If this DLCI has an alternative endpoint to which this DLCI can be switched
if it becomes inactive, the endpoint index of this alternative endpoint would
be configured here.
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
SLP Reference
Endpoint
This is the reference endpoint index to use for the Service Level Agreement
parameters. As most applications have the same SLAs for all DLCIs, they
only need to be configured in one DLCI entry. You can then copy the SLA
parameters from the endpoint index of this configured DLCI. If no SLP
reference endpoint is configured and the DLCI SLA parameters are not
configured, the values in the Frame Relay Service Details will be used
(default CIR, Be, enforcement).
For most applications, you will not need to set this parameter.
Values: 0–256
Default: 0
Remote IP Address If this WANsuite 5165 unit is to be used to manage a remote WANsuite 5165
unit, you must configure the IP address of the remote WANsuite 5165 unit
here. This DLCI can be used for management only, or for management and
actual data.
If this parameter is set, a PC connected to the LAN interface of this
WANsuite 5165 can reach a remote WANsuite 5165 through this DLCI. The
remote IP address must be part of an network that is different from the local
WANsuite 5165, and the local WANsuite 5165's IP address must be
configured into the PC. This way, local and remote WANsuite 5165s can be
reached regardless of the availability of the routers connected at the back of
the WANsuite 5165s.
Values: IP address
Default: 0.0.0.0
Remote IP Mask If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type If data received from this DLCI has to be switched to its corresponding
destination port, you must set the type to “Switched.” Set the type to “Local”
for any DLCI used for management purposes only.
Values: Switched, Local
Default: Switched
New DLCI This field is used to create a new DLCI if it is not already configured. To
create a new DLCI, enter a valid DLCI number in the field and click the
“Submit” button. The new DLCI number will be reflected in the DLCI field
of the Endpoint Details screen.