Verilink WANsuite 5165 (34-00301.H) Product Manual - Manual (Page 155)

V T 1 0 0 I n t e r f a c e 4-31
changes state, provided at least one destination IP address for trap is
configured in the SNMP configuration.
Values: Disable, Enable
Default: Disable
Rx Invalid Threshold Number of invalid frames received during a 15-minute interval after which an
Rx invalid alarm will be triggered. A value of “0” (zero) disables this trap.
Values: 0–4294967295
Default: 0
Rx Invalid Alarm Status of this alarm (OK, Alarmed).
User prompts at the bottom of the Frame Relay Services Details screen are
described in the following table:
Frame Relay Statistics Screen
Select the “Frame Relay Statistics” prompt to bring up a table (Figure 4.25)
that reports on the status and condition of LMI parameters and on Receive/
Transmit alarms and thresholds. Alarm threshold levels may be changed by
entering a new threshold value in the appropriate field on the Frame Relay
Service Details screen and pressing the “Esc” key
Prompt Function
Frame Relay
Statistics
Opens the Frame Relay Statistics screen for the current frame
relay service.
Clear Alarms Clears ALL frame relay alarms.
Pair Type Details Opens another Frame Relay Service Details screen that reverses
the service and the pair so that you can view both sides of the
pair.
DLCI Table Opens the DLCI Table screen, which displays all the DLCIs on
the current service. Refer to DLCI Table Screen on page 4-49 for
more information.