Bios settings, Frame bios settings – Grass Valley Kayak HD Installation v.6.9.4 Jun 02 2011 User Manual
Page 196
196
Kayak HD — Installation and Service Manual
Section 4 — Maintenance
BIOS Settings
Frame BIOS Settings
Figure 148. Side View PS/2 and VGA Sockets on the Kayak HD Controller Processor Board
1.
Connect a computer keyboard to the PS2 connector on the frame
controller processor board and a computer monitor VGA plug to the
VGA socket.
2.
Press and hold the
F2
key immediately while booting the switcher to
display the BIOS Menu.
3.
Load
BIOS Setup Default
with the key
F9
and confirm by clicking
Yes
.
4.
Select the
Advanced
menu.
a.
Select
PCI/PNP Configuration
and press
Enter
.
b.
Set
PNP OS Installed
to
No
. Press
ESC
to return to the
Advanced
menu.
5.
In the
Advanced
menu select
I/O Device Configuration
and press
Enter
.
a.
Set
Legacy USB Support
to
Disabled
.
b.
Set
Serial Port A
to
Enabled
.
c.
Set
Serial Port B
to
Enabled
. Press
ESC
to return to the
Advanced
menu.
6.
Select the
Power
menu at the top of the screen.
a.
Set
Enable ACPI
to
No
.
7.
Select the
Boot
menu at the top of the screen.
a.
Select
Sandisk
(or
Removable Devices
) and make sure it is the first
priority in the Boot menu. (This is the Compact Flash Card installed
on the Kayak HD frame.)
ON
OFF
PS2
Keyboard
VGA
8448_59_
r0
M/E 0
M/E 1
Controller
Processor Board