Calling the tool data – HEIDENHAIN NC 124 User Manual
Page 29
3
Manual Operation and Setup
TNC 124
29
MOD
Example: Calling the tool data
MOD
Select the user parameters.
Go to the first soft-key row containing Tool Table.
5
ENT
Select the tool table.
Enter the tool number (here: 5) and confirm your entry with ENT.
/
T o o l n u m b e r ?
Activate the tool and depart the user parameters.
Select the Tool axis (Z).
Enter the tool radius (8 mm) and confirm your entry with ENT.
ENT
8
T o o l r a d i u s ?
MOD
Depart the user parameters.
Calling the tool data
The lengths and radii of your tools must first be entered into the
TNC's tool table (see previous page).
Before you start workpiece machining, select the tool you are using
from the tool table. To call the desired tool, move the highlight to the
tool, select the axis with the corresponding soft key and press the
soft key Tool Table.
The TNC then takes into account the stored tool data when you
work with tool compensation (e.g., with hole patterns).
Fig. 3.6:
The tool table on the TNC screen
You can also call the tool data with the command
TOOL CALL
in a program.