HEIDENHAIN NC 124 - Manual (Page 70)

5 Programming
70 TNC 124
Entering dwell time
You can enter a dwell time in the part program by pressing the soft
key Dwell Time and defining the block DWELL XXXX.XXX.
When the DWELL block is executed, continuation of the running
program is delayed by the time entered in seconds for DWELL.
Operating mode: PROGRAMMING AND EDITING
Go to the third soft-key row.
Call dwell time.
/
D w e l l t i m e i n s e c o n d s ?
Enter the dwell time in seconds (such as 8).
Confirm entry. Input range: 0 to 9999.999. ENT 8