HEIDENHAIN NC 124 - Manual (Page 60)

5 Programming
60 TNC 124
Entering a program number
Select a program and identify it by a number between 0 and
9999 9999 which you assign it.
Operating mode: PROGRAMMING AND EDITING
ENT
or
When you select the unit of measurement with the soft
key inch/mm, the TNC overwrites the user parameter
inch/mm.
Program directory
The program directory appears when you choose the soft key Pro-
gram Number
. The number in front of the slash is the program
number, the number behind the slash is the number of blocks in the
program.
A program always contains at least two blocks.
Deleting programs
If you no longer wish to keep a program in memory,
you can delete it:
➤ Press the soft key Program Manage.
➤ Press the soft key Delete Program.
➤ Enter the program number.
➤ Press ENT to delete the program.
1
or
/ /
Select Program Manage.
Go to the program directory.
Choose the unit of measurement.
Confirm your entry.
The selected program can now be entered, edited and run.
Select an existing program with the cursor keys.
P r o g r a m n u m b e r ?
Create a new program or select an existing program,
such as program number 1.