Install the ethernet/ip option card on the drive – Yaskawa CM092 User Manual
Page 11
Installation 1-6
Install the EtherNet/IP Option Card on the Drive
1.
Connect the RJ-45 M-F cable supplied in this kit to the EtherNet/IP Option Card.
2.
Connect the ground wire supplied to ground terminal J6 on the EtherNet/IP Option Card.
3.
Align the J2 connector on the back of the EtherNet/IP Option Card with its mating 2CN connector on the drive control card.
4.
Align the two standoffs on the front of the drive control board with the two holes on the right side of the EtherNet/IP Option Card.
5.
Press the EtherNet/IP Option Card firmly onto the drive 2CN connector and standoffs until the J2 connector is fully seated on 2CN and
the drive standoffs have locked into their appropriate holes.
6.
Route the RJ-45 M-F cable and the ground wire along the left-inside of the AC drive enclosure.
7.
Replace the option card hold-down.
8.
Connect the ground wire from the option card terminal J6 to the terminal assembly ground connection.
Fig 1.2 – Install the CM092 on an F7U Drive