Yaskawa CM092 - Manual (Page 7)

Installation 1-2
Installation Check Sheet
The following is a quick reference checklist to install and configure the EtherNet/IP Option Card. Make a copy of this page and check-off ;
each item as it is completed. For detailed information please refer to the detailed sections that follow.
1. † Unpack the EtherNet/IP Option Card and verify that all components are present and undamaged.
2. † Connect and power the drive and verify that the drive runs normally.
Refer to the appropriate user, programming or technical manual for details on connecting and starting the AC drive.
4. † Install the EtherNet/IP Option Card on the drive.
5. † Connect the EtherNet/IP Option Card to the EtherNet/IP communication network.
6. † Apply power to the drive and check diagnostic and normal operation LED status.
7. † Configure the PC for a network connection.
8. † Configure the EtherNet/IP Option Card.
9. † Finish the EtherNet/IP Option Card Installation:
Refer to the documentation included with the EtherNet/IP configuration utility supplied with the EtherNet/IP Master controller.
Verify that the drive appears on the EtherNet/IP network at the correct IP address, Subnet Mask, gateway and server.
Dangerous voltages in excess of 400VDC (230V drives) or 800VDC
(460V drives) are present at the DC bus terminals of the drive.
WARNING!