TA Triumph-Adler DCC 2725 - Manual (Page 313)

Default Setting (System Menu)
8-73
8
Network Setup
The following network settings are available.
• Checking Host Name …8-73
• TCP/IP (IPv4) Setup …8-73
• TCP/IP (IPv6) Setup …8-73
• Protocol Detail …8-75
• NetWare Setup …8-76
• AppleTalk Setup …8-76
• WSD Scan Setup …8-76
• WSD Print Setup …8-77
• Secure Protocol …8-77
• IPSec Setting …8-79
• LAN Interface Setup …8-79
Checking Host Name
Check the host name of the machine. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network. Check the host name displayed under Host Name.
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to TCP/IP (IPv4) Setup (by Entering IP Addresses) on page 2-13 about the procedures.
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default settings are "TCP/IP Protocol: On, TCP/IP (IPv6):
Off. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next] of TCP/IP Setting.
3 Press [Change] of TCP/IP.
4 Press [On] and then press [OK].
5 Press [Next] of IPv6.
6 Press [Change] of IPv6.
7 Press [On]. IP Address (Link Local) appears.
8 Press [OK].
9 After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-72.