TA Triumph-Adler P-C2660i MFP - Manual (Page 64)

2-28
Preparation before Use > Energy Saver function
Sleep and Auto Sleep
To enter Sleep, press the Energy Saver key. Touch panel and all indicators on the operation
panel will go out to save a maximum amount of power except the Energy Saver key, and Main
Power indicators. This status is referred to as Sleep.
If print data is received during Sleep, the touch panel lights up and printing starts.
If you are using the products equipped with the fax function, received data is printed out while
the operation panel remains unlit.
To resume, press the Energy Saver key. The machine will be ready to use within 20 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to
respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time. The
default preset time is 15 minutes.
For more information about configuring settings, refer to Sleep Timer on page 9-27.
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. In addition, it takes longer for the
machine to wake and return to normal operation.
For more information on Sleep Rules settings, refer to Sleep Rules (models for Europe) on page 9-
27.
Sleep Level (Energy Saver) (models except for Europe)
This mode reduces power consumption even more than normal Sleep mode, and allows Sleep
Mode to be set separately for each function. The time required for the machine to wake up
from power save mode and resume normal operation will be longer than for normal Sleep
Mode.
For more information on Sleep Level (Energy Saver) Mode settings, refer to Quick Setup Wizard on
page 3-29.
NOTE
When a preset time of Low Power Timer and Sleep Timer is same, Sleep Mode overrides
Low Power Mode.
NOTE
If the optional network interface kit is installed, Energy Saver cannot be specified.