Setting up crestron connected – Epson BrightLink 1485Fi 5000-Lumen Pixel-Shift Full HD Ultra-Short Throw 3LCD Interactive Laser Projector User Manual
Page 97
97
Setting Up Crestron Connected
To set up your projector for monitoring and control using a Crestron Connected system, make sure your
computer and projector are connected to the network.
Note:
If you want to use the Crestron Connected system when the projector is turned off, you need to
adjust the Standby Mode setting in the Operation menu. The Standby Mode setting is displayed only if
the A/V Output setting in the Signal I/O menu is set to
While Projecting
, the Auto Power On setting in
the Network menu is set to
Off
, and the Power On Trigger setting in the Operation menu is set to
Plug-in
Detection
.
1.
Press the
Menu
button.
2.
Select the
Network
menu and press
Enter
.
3.
Select
Network Settings
and press
Enter
.
4.
Select the
Projector Control
menu and press
Enter
.
5.
Set the
Crestron Connected
setting to
On
to allow the projector to be detected.
Note:
Enabling Crestron Connected disables the Message Broadcasting feature in the Epson
Projector Management software.
6.
When you are finished selecting settings, select
Return
and press
Enter
to return to the
Network
Settings
menu.
7.
Select
Set
, and follow the on-screen instructions to save your settings and exit the menus.
8.
Turn off the projector, then turn it on again to enable the setting.
9.
Start your Web browser on a computer or device connected to the network.
10. Go to the
Epson Web Control
screen by entering the projector's IP address into the browser's
address box.
11. Select the
Crestron Connected
settings. See the Crestron Web site for details.
Parent topic:
Related references
Input Signal Settings - Signal I/O Menu
Network Settings - Network Menu
Feature Settings - Operation Menu