Solutions to remote control problems – Epson EpiqVision Ultra LS800 4000-Lumen Pixel-Shift 4K UHD Ultra-Short Throw Laser 3LCD Smart Home Theater Projector (Black) User Manual
Page 123
123
Related tasks
Cleaning the Obstacle and Motion Sensors
Solutions to Remote Control Problems
If the projector does not respond to remote control commands, try the following solutions:
• Check that the remote control batteries are installed correctly and have power. If necessary, replace
the batteries.
• Make sure you are operating the remote control within the reception angle and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to enter sleep mode. Release
the button to wake the remote control up.
• Check the status indicator to confirm that the projector is in normal operating status.
• Check that the input source is not set to
HDMI3 (Game)
; otherwise, some buttons on the remote
control are not available.
• Make sure the remote control is paired to the projector to operate Android TV features. If the pairing
screen is displayed, perform pairing again by holding down the
Enter
and
home buttons on the
remote control simultaneously for about three seconds.
Note:
You can use a keyboard or mouse connected to the USB-A port on the projector to get to the
remote control pairing screen.
• Strong fluorescent lighting, direct sunlight, or infrared device signals may be interfering with the
projector's remote receivers. Dim the lights or move the projector away from the sun or interfering
equipment.
• If you lose the remote control, you can purchase another from an Epson parts distributor.
• If the projector's remote control cannot communicate with the projector in a rear projection setup, you
may need 3rd-party IR extenders or a control system.
Parent topic:
Solving Projector or Remote Control Operation Problems
Related references
Projector Light Status
Remote Control Operation
Related tasks