Uniview IPC675LFW-AX4DUPKC-VG 5MP Outdoor Mini PTZ Active Deterrence Network Camera with Night Vision - Manual (Page 134)

129
CAUTION!
Restarting the camera will interrupt the ongoing service.
Click Restart and then confirm to restart the device. You may set a schedule to reboot the camera
automatically at the set time.

Heater
Use the heater to eliminate water droplets on the lens in a high humidity environment.
(1) Enable Heater.
(2) Set
Remaining Heating Time .
2. Network Diagnosis
Go to Setup > System > Maintenance > Network Diagnosis .

Select NIC
NIC1 is the camera’s IP address.

IP/port filter
 All: Capture all packets of the camera.
 Specify: Capture packets of the specified port or IP.
 Filter: Filter packets of the specified port or IP and capture other packets.

Custom Rules
Select Custom Rules and set the rules.
Click Start Capture to start capturing packets. After packet capture is finished, save data and view the
diagnosis.

Test network delay and packet loss rate
Test network connectivity by sending test packets to a test address.
 Test Address: Must be a valid IP address or domain name.
 Packet Size (Bytes): Size of test packets to be sent. Range: [64-65507]. Sometimes a high delay
may be caused by a large packet size. If the test failed, set a smaller packet size and then try
again.