Uniview IPC675LFW-AX4DUPKC-VG 5MP Outdoor Mini PTZ Active Deterrence Network Camera with Night Vision - Manual (Page 39)

34
At present, QoS allows you to assign different priority to audio and video, alarm report, configuration
management and FTP transmission. The greater the value, the higher the priority.
As shown in the figure above, the audio & video service takes priority over all other services in case of
network congestion.
NOTE!
To use QoS, make sure that the router or switch is also configured with QoS.
Click Save .
5.2.10 WebSocket
WebSocket allows you to manage your camera on a third-party platform, such as device version and
capability information acquisition, PTZ control, alarm reporting, etc.
Go to Setup > Network > WebSocket .
Set the parameters.
Item Description
WebSocket Select to enable or disable WebSocket.
Destination IP Enter the IP address of the third-party platform.
Destination
Port
Enter the listener port of the third-party platform.
Device ID The default device ID is the device’s serial number. You can set a device ID as needed.
Authentication
Key
Enter the authentication key used to connect the camera to a third-party platform. Make sure the
authentication key configured on the camera and the third-party platform is the same.
Confirm
Authentication
Key
Confirm the authentication key you entered by entering it again.
Online Status Check whether the device is successfully connected to the third-party platform.
Click Save .
5.3
Video & Audio
For dual-channel devices, you can set video and audio parameters for the channels separately.