Hitachi SJ200 Series - Manual (Page 247)

SJ200 Inverter
Appendix B
B–33
B021 Overload restriction
operation mode R/W Select the operating mode
during overload conditions,
three options, option codes:
00... Disabled
01... Enabled for acceleration
and constant speed
02... Enabled for constant
speed only
0092h 0, 1, 2 —
B022 Overload restriction
setting R/W Sets the level for overload
restriction, between 20% and
150% of the rated current of
the inverter, setting resolution
is 1% of rated current
0093h 2000 to
15000
0.01%
B023 Deceleration rate at
overload restriction R/W Sets the deceleration rate when
inverter detects overload, range
is 0.1 to 30.0, resolution is 0.1
0094h 1 to 300 0.1 sec
B031 Software lock mode
selection R/W Prevents parameter changes, in
four options, option codes:
00... all parameters except
B031 are locked when [SFT]
terminal is ON
01... all parameters except
B031 and output frequency
F001 when [SFT] terminal is
ON
02... all parameters except
B031 are locked
03... all parameters except
B031 and output frequency
F001 setting are locked
0095h 0, 1, 2, 3 —
B080 [AM] analog signal
gain R/W Adjust of analog output at
terminal [AM],
range is 0 to 255
0096h 0 to 255 —
B082 Start frequency adjust-
ment R/W Sets the starting frequency for
the inverter output, range is 0.5
to 9.9 Hz
0098h 5 to 99 0.1 Hz
B083 Carrier frequency
setting R/W Sets the PWM carrier (internal
switching frequency), range is
2.0 to 14.0 kHz
0099h 20 to
140
0.1 Hz
B084 Initialization mode
(parameters or trip
history) R/W Select the type of initialization
to occur, two option codes:
00... Trip history clear
01... Parameter initialization
02... Trip history clear and
parameter initialization
009Ah 0, 1, 2 —
“B” Group Fine Tuning Functions
Func.
Code
Name R/W Description
Network Data
Reg. Range Res.