Control switch settings (ctrl switch), Tempo, Mfx ctrl ch – Roland Fantom-X7 User Manual
Page 118: 118 creating a performance
118
Creating a Performance
Tempo
fig.09-018_50
For details on these settings, refer to
Controlled by the Realtime Controllers or D Beam
Recommended Tempo
If you want the sequencer tempo to change when you switch
Performances, specify the tempo that will follow this change. This
setting is valid when the Seq Tempo Override parameter is “ON.” In
order to enable this setting, turn on the Tempo Override parameter
(p. 227).
Value:
20–250
*
This value is specified independently for each performance. This means
that when you switch performances, the tempo setting of the Fantom-
X will change.
*
The sequencer tempo will be overwritten to the new tempo when you
switch performances.
MFX Ctrl Ch
fig.09-019_50
For details on these settings, refer to
Controlled by the Realtime Controllers or D Beam
MFX 1–3 Control Channel
Select the channel to which the multi-effect will be applied. Control
to modify multi-effects parameters in realtime, when MFX1–3 Source
parameter is set to “Prf.” Set to “OFF” when the Multi-effects
Control is not being used.
Value:
1–16, OFF
You can change controller switch on/off settings for each patch in
the performance.
1.
In the Control Setting (Performance) screen, press [F7 (Ctrl
Switch)].
fig.09-012_50
2.
Use [CURSOR] to move the cursor to the parameter you
wish to modify.
3.
Turn the VALUE dial or press [INC]/[DEC] to get the value
you want.
4.
Repeat steps 2-3 to set each parameter you want to edit.
5.
Press [F8 (EXIT)] to return to the previous screen.
Control Bender (Control Pitch Bend Switch)
For each part, specify whether MIDI Pitch Bend messages will be
transmitted (ON), or not (OFF).
Value:
OFF, ON
Control Aftertouch (Control Aftertouch Switch)
For each part, specify whether MIDI Aftertouch messages will be
transmitted (ON), or not (OFF).
Value:
OFF, ON
Control Modulation (Control Modulation
Switch)
For each part, specify whether MIDI Modulation messages will be
transmitted (ON), or not (OFF).
Value:
OFF, ON
Control Hold Pedal (Control Hold Pedal Switch)
For each part, you can specify whether control messages from a
pedal connected to the HOLD PEDAL jacks will be transmitted
(ON), or not (OFF).
Value:
OFF, ON
Control Pedal (Control Pedal Switch)
For each part, you can specify whether control messages from a
pedal connected to the CONTROL PEDAL jacks will be transmitted
(ON), or not (OFF).
Value:
OFF, ON
Control Switch Settings (Ctrl Switch)
Fantom-X678_r_e.book 118 ページ ２００５年５月１２日 木曜日 午後４時４０分