Roland Fantom-X7 - Manual (Page 173)

173
Recording Songs
4. Turn the VALUE dial or press [INC]/[DEC] to add a check
mark.
The message will be recorded if you assign a check mark ( ✔ ),
and will not be recorded if you remove the check mark.
If you press [F6 (All Off)], no sequencer data will be recorded.
If you press [F7 (All On)], all of the sequencer data will be
recorded.
5. Press [F8 (Close)] to close the Recording Select window.
Realtime Erase is a function that erases unwanted data during
realtime recording. This is particularly convenient during loop
recording, since it lets you erase data without stopping recording.
Realtime Erase can be executed only if the Recording Mode is
set to “MIX.”
You can also erase the data of a specific channel.
1. Begin realtime recording (p. 170).
The Realtime Recording window appears.
fig.18-004_50
2. Press [F6 (Erase)].
The Realtime Erase window appears.
fig.18-008_50
3. Erase unwanted data.
To erase all data (except for Pattern Call messages), press [F7
(Erase All)]. Data will be erased for as long as you hold down
the button.
To erase notes of a specific key, hold down that key. Data for
that note will be erased for as long as you hold down that key.
To erase notes of a specific key range, hold down the top and
bottom keys of that range. Data for that range will be erased for
as long as you hold down those keys.
4. Press [F8 (Close)] to close the Realtime Erase window.
You will return to the normal recording state.
* You can also erase the data of a specific channel.
When recording arpeggios in real time, you can synchronize the
arpeggio with the sequencer start/stop timing.
For details, refer to “Arpeggio/Rhythm Sync Switch” (p. 227).
The Rehearsal function lets you temporarily suspend recording
during realtime recording. This is convenient when you want to
audition the sound that you will use next, or to practice the phrase
that you will record next.
1. Begin realtime recording (p. 170).
The Realtime Recording window appears.
fig.18-004_50
2. Press [F7 (Rehearsal)] or [REC].
The [REC] indicator will blink, indicating that you are in
rehearsal mode. In this state, nothing will be recorded when
you play the keyboard.
3. To return to record mode, press [F7 (Rehearsal)] or [REC]
once again.
Erasing Unwanted Data While You
Record (Realtime Erase)
Recording Arpeggios Aligned to
the Measures of the Sequencer
Auditioning Sounds or Phrases
While Recording (Rehearsal
Function)
Fantom-X678_r_e.book 173 ページ ２００５年５月１２日 木曜日 午後４時４０分