Roland Fantom-X7 - Manual (Page 151)

151
Editing a Sample
Here’s how to assign samples as the rhythm tones of a rhythm set.
For example, you can create an original rhythm set by replacing
certain tones of a preset rhythm set with different samples.
* From the Sample List screen you can also press [F7 (Load Utility)]->
[F2 (Assign to Pad)] to execute Assign To Pad.
* You cannot execute this with more than one sample selected.
1. Press [SAMPLE LIST] to select a sample, and then press
[SAMPLE EDIT] to access the Sample Edit screen.
2. Press [F6 (Assign KB/Pad)].
The Assign to Kbd/Pad screen will appear.
fig.15-009_50
3. Press [F7 (Assign to Pad)].
The Assign to Pad screen will appear.
fig.15-010_50
4. Select the desired pad by pressing it directly.
If you press [F1 (Tempo Sync)] to light it into red, the Wave
Tempo Sync parameter (p. 89) will be turned ON for the rhythm
tone that is assigned.
5. Press [F8 (Exec)].
A message will ask your confirmation.
6. Press [F8 (Exec)] to execute Assign to Pad.
The sample will be assigned (as a rhythm tone) to the specified
pad.
To cancel, press [F7 (Cancel)].
7. Press [EXIT] to return to the previous screen.
Before you continue with the procedure below, make sure you're in
Performance mode, and select the patch or rhythm set to which you
want to assign the sample.
1. Press [SAMPLE LIST] to select a sample, and then press
[SAMPLE EDIT] to access the Sample Edit screen.
2. Press [F6 (Assign KB/Pad)].
The Assign to Kbd/Pad screen will appear.
3. Press [F7 (Assign to Pad)].
The Assign to Pad screen will appear.
If a rhythm set is not assigned to the selected part, a message
will ask “Change into Rhythm and Initialize?”, asking if you
want to assign an initialized rhythm set to the selected part.
fig.15-010_50
4. Select the desired pad by pressing it directly.
If you press [F1 (Tempo Sync)] to light it into red, the Wave
Tempo Sync parameter (p. 63) will be turned ON for the rhythm
tone that is assigned.
5. Press [F8 (Exec)].
A message will ask your confirmation.
6. Press [F8 (Exec)] to execute Assign to Pad.
The sample will be assigned (as a rhythm tone) to the specified
pad.
To cancel, press [F7 (Cancel)].
7. Press [EXIT] to return to the previous screen.
If you select another rhythm set, the rhythm set you assigned
will be replaced by that patch. If you want to keep the patch you
created, press [WRITE] and save it.
Assigning Samples to a Pad
(Assign To Pad)
From Patch Mode
From Performance Mode
Fantom-X678_r_e.book 151 ページ ２００５年５月１２日 木曜日 午後４時４０分