231 settings common to all modes (system function) – Roland Fantom-X7 User Manual
Page 231
231
Settings Common to All Modes (System Function)
Soft Through (Soft Through Switch)
Thru function re-transmits all messages received at the MIDI IN
connector to the MIDI OUT connector without modifying them in
any way.
Value:
OFF, ON
Remote Keyboard Sw (Remote Keyboard
Switch)
Set this parameter “ON” when you want to use an external MIDI
keyboard instead of the Fantom-X’s keyboard. In this case, the MIDI
transmit channel of the external MIDI keyboard can be set to any
channel. Normally you will leave this parameter “OFF.”
Value:
OFF, ON
Turn this “ON” when you want to control the Fantom-X from
an external MIDI device when performing with the Arpeggio or
RPS function.
Receive Program Change (Receive Program
Change Switch)
Specifies whether Program Change messages will be received (ON)
or not (OFF).
Value:
OFF, ON
Receive Bank Select (Receive Bank Select
Switch)
Specifies whether Bank Select messages will be received (ON) or not
(OFF).
Value:
OFF, ON
Receive Exclusive (Receive System Exclusive
Switch)
Specifies whether System Exclusive messages will be received (ON)
or not (OFF).
Value:
OFF, ON
Receive GM System On (Receive GM System
On Switch)
Specifies whether General MIDI System On messages will be
received (ON) or not (OFF).
Value:
OFF, ON
Receive GM2 System On (Receive GM2 System
On Switch)
Specifies whether General MIDI 2 System On messages will be
received (ON) or not (OFF).
Value:
OFF, ON
Receive GS Reset (Receive GS Reset Switch)
Specifies whether GS Reset messages will be received (ON) or not
(OFF).
Value:
OFF, ON
USB Mode
Selects the mode in which the USB connector will be used.
Value:
Storage:
Storage mode. Select this if you want to transfer files.
MIDI:
MIDI mode. Select this if you want to exchange MIDI
messages with a sequencer or other program.
You must switch the USB Mode before you connect the Fantom-
X to your computer via the USB cable. If you change this setting
while the Fantom-X is connected, the computer may fail to
recognize it correctly.
For details on connections to your computer in each USB Mode,
refer to
USB-MIDI Thru Sw (USB-MIDI Thru Switch)
When USB Mode is set to “MIDI,” this switch specifies whether
MIDI messages received at the MIDI connector will be retransmitted
from the MIDI OUT connector (ON) or not (OFF).
Value:
OFF, ON
USB
Fantom-X678_r_e.book 231 ページ ２００５年５月１２日 木曜日 午後４時４０分