Roland Fantom-X7 - Manual (Page 35)

35
Overview of the Fantom-X
To modify the value, use the VALUE dial or the [INC]/[DEC]
buttons.
fig.04-021
In each screen of the Fantom-X, you can use the cursor to move
the area displayed as highlighted, and modify its value.
Each parameter has its own range of possible values, so you
cannot set any value smaller than the minimum value or greater
than the maximum value.
VALUE Dial
Rotating the VALUE dial clockwise increases the value,
counterclockwise decreases the value. Holding down [SHIFT] as you
move the VALUE dial increases value increments so you can make
large value changes faster.
[INC] and [DEC]
Pressing [INC] increases the value, and [DEC] decreases it. Keep the
button pressed for continuous adjustment. For faster value increases,
keep [INC] pressed down and press [DEC]. For decreasing value
faster, keep [DEC] pressed down and press [INC].
If you press [INC] or [DEC] while holding down [SHIFT], the value
increments will get bigger.
Using the pads
In some cases when the cursor is located at an input location, you
can press [ENTER] to see a list of parameter values. For some of
these lists, the screen will show an icon like the following, which
means you can use the pads to input or specify the value.
When inputting a numerical value
fig.04-021a
PAD 1–9: Input numerals 1–9
PAD 10: Input the numeral 0
BS: Cancels the numeral you input
DEL: Cancels the lowest place of the number you input. If you’ve
input “15,” pressing DEL will change the value to “1.”
When inputting directly
fig.04-021a
Pressing a pad will directly input the corresponding value. From the
top, the items in the list correspond to pads 1–16.
Modifying a Value
When the cursor is located at a parameter value, press [ENTER]
to display a window where you can set the value. Use
to select a value, and then press [ENTER] to finalize the setting.
Fantom-X678_r_e.book 35 ページ ２００５年５月１２日 木曜日 午後４時４０分