Roland Fantom-X7 - Manual (Page 18)

18
Panel Descriptions
fig.01-002
fig.01-003
POWER ON Switch
Press to turn the power on/off. -> (p. 21, p. 22)
AC Inlet
Connect the included power cord to this inlet. -> (p. 21)
fig.01-004
CTL (CONTROL) PEDAL Jack
You can connect optional expression pedals (EV-5, etc.) to these
jacks. By assigning a desired function to a pedal, you can use it to
select or modify sound or perform various other control. You can
also connect optional pedal switches (DP series etc.) to sustain
sound. -> (p. 25)
925
* Use only the specified expression pedal (EV-5; sold separately). By
connecting any other expression pedals, you risk causing malfunction
and/or damage to the unit.
HOLD PEDAL Jack
An optional pedal switch (DP series etc.) can be connected to this
jack for use as a hold pedal. -> (p. 24)
This can also be set so it supports the use of half-pedaling
techniques. So, after connecting an optional expression pedal (DP-8,
etc.), you can employ pedal work to achieve even finer control in
performances in which piano tones are used.
fig.01-005
MIDI Connectors (IN, OUT, THRU)
These connectors can be connected to other MIDI devices to receive
and transmit MIDI messages.
fig.01-006
DIGITAL IN/OUT Connectors (S/P DIF COAXIAL)
These are coaxial-type S/P DIF format digital in/out connectors.
These connectors input and output a digital audio signal (stereo).
The output signal is identical to the signal that is output from the
OUTPUT A (MIX) jacks.
* S/P DIF is a digital interface format used for consumer digital audio devices.
fig.01-007, 008
OUTPUT A (MIX) Jacks (L (MONO), R)
These jacks output the audio signal to the connected mixer/amplifier
system in stereo. For mono output, use the L jack. -> (p. 19)
OUTPUT B Jacks (L, R)
These jacks output the audio signal to the connected mixer/amplifier
system in stereo.
INDIVIDUAL 1–4 Jacks
These jacks output audio signals in mono to an amp or mixer.
The setting determining whether these jacks are used as stereo
OUTPUT jacks or monaural INDIVIDUAL jacks is made with the
Output Assign setting (p. 207).
AUDIO INPUT Jack (L, R)
Accept input of audio signals in stereo (L/R) from external devices.
If you want to use mono input, connect to the L jack.
When recording from a mic, connect it to the L jack, and set Input
Select (p. 141) to “MICROPHONE.”
PHONES Jack
This is the jack for connecting headphones (sold separately). -> (p.
19)
fig.01-003a
PC CARD Slot
A memory card can be inserted here. -> (p. 244, p. 246)
931
* Carefully insert the memory card all the way in-until it is firmly in
place.
USB Connector
This connector lets you use a USB cable to connect your computer to
the Fantom-X. -> (p. 218)
Rear Panel
Fantom-X678_r_e.book 18 ページ ２００５年５月１２日 木曜日 午後４時４０分