Roland Fantom-X7 - Manual (Page 132)

132
Playing Arpeggios
In this method, you’ll use the cursor to specify the step or pitch that
you want to input, and use the dial or [INC][DEC] to input values.
This method is convenient when you want to edit or modify
previously input data.
1. Hold down [SHIFT] and press [ARPEGGIO].
2. Press [F7 (Edit)].
The Arpeggio Style Edit screen will appear.
3. Press [F1 (Arp Setup)].
The Arpeggio Setup screen will appear.
4. Move the cursor to “End Step,” and specify the number of
steps for the arpeggio style you want to create.
Make the desired setting, and then press [F8 (Close)] to close the
Arpeggio Setup screen.
5. Use [CURSOR] to specify the step or pitch you want to
input.
* When using this method of input, you can use the keyboard to specify
the pitch of the note. (Unlike when step-recording, pressing the
keyboard will not actually input the note.)
6. Input the velocity value, using either the VALUE dial or
[INC][DEC].
You can input a tie by turning VALUE all the way to the right
(or using [INC] to raise the value all the way).
* You can also input a tie by pressing [F2 (TIE)].
* To input a rest, press [F3 (Rest (Clear))].
* You can use [F4 (Zoom In)]/[F5 (Zoom Out)] to zoom the display in
or out.
* You can press [F6 (Preview)] to audition the style you’ve input.
* When using this method of input, you can use the pads to specify the
velocity and finalize your input; after you’ve specified the step and
pitch to be input, strike a pad to input it.
(Higher-numbered pads produce higher velocity values; for example,
striking pad 1 specifies a velocity value of 8, while striking pad 16
specifies a velocity value of 127.)
A maximum of sixteen note numbers (pitches) can be used in a
single style.
The Styles you create are temporary; they are deleted as soon as you
turn off the power or select some other Style. You can store 128
arpeggio styles in the User memory.
1. Confirm that the current Style is the one you want to save.
2. Press [F3 (Arp)].
3. Press [F8 (Write)].
The Arpeggio name entry screen will appear (p. 36).
4. When you have finished entering the name, press [F8
(Write)].
A screen in which you can select the destination for the write
will appear.
fig.11-008_50
5. Turn the VALUE dial or use [INC] [DEC] to select the write
destination.
6. Press [F8 (Write)].
A message will ask you for confirmation.
7. To write the data, press [F8 (Exec)].
Never switch off the Fantom-X while data is being saved.
* To cancel, press [F7 (Cancel)].
Using the Dial or [INC][DEC] to
Input Values
Saving the Styles You Have
Created (Write)
Arpeggio style settings are saved as independent data, not
as part of the data for each patch. The settings in Patch mode,
it is not possible to save arpeggio parameters (e.g., arpeggio
style, grid type, motif, duration, octave range).
It can be saved to individual in Performance mode. If you
want to save your settings, press [WRITE] and save the
performance.
Fantom-X678_r_e.book 132 ページ ２００５年５月１２日 木曜日 午後４時４０分