Roland Fantom-X7 - Manual (Page 124)

124
Modifying the Sound in Real Time
Resonance
Emphasizes the portion of the sound in the region of the cutoff
frequency, adding character to the sound. Excessively high settings
can produce oscillation, causing the sound to distort.
Value: 0–127
Level
Sets the volume.
Value: 0–127
Chorus Send Level
Sets the level of the signal sent to chorus.
Value: 0–127
Reverb Send Level
Sets the level of the signal sent to reverb.
Value: 0–127
LFO Rate
Adjusts the modulation rate, or speed, of the LFO.
Value: 0–127
LFO Osc 1 Pitch Depth
Specifies the depth to which the LFO will modulate the OSC1 pitch.
Value: -63–+63
LFO Osc 2 Pitch Depth
Specifies the depth to which the LFO will modulate the OSC2 pitch.
Value: -63–+63
LFO Osc 1 Pulse Width Depth
Specifies the depth to which the LFO will modulate the pulse width
of the OSC1 waveform.
* The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.
Value: -63–+63
LFO Osc 2 Pulse Width Depth
Specifies the depth to which the LFO will modulate the pulse width
of the OSC2 waveform.
* The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.
Value: -63–+63
Range (Solo synth range)
Specifies the range in which the pitch of the solo synth will vary.
Value: 2 OCTAVES, 4 OCTAVES, 8 OCTAVES
You can use the REALTIME CONTROL knobs and ASSIGNABLE
SW buttons to modify the sound in real time.
1. Access the Patch Play screen (p. 38).
The “Realtime Control” area shows the function that is assigned
to each realtime controller knob and button. [ ] indicate the
four knobs, and [ ], [ ] indicate the two buttons.
fig.10-007.e
2. You can select the function of the knobs by pressing the
button located at the right of the realtime control knobs.
The parameter display at the bottom of the screen will also
change.
• If the FILTER/ENV indicator is lit
Turning the knobs will control Cutoff, Resonance, Attack, and
Release.
• If the ARP/RHY indicator is lit
Turning the knobs will control the arpeggio parameters Range
and Accent, and the rhythm parameters Accent Rate and
Tempo.
• If the ASSIGNABLE indicator is lit
Turning the knobs will control the assigned parameters. You
can freely assign parameters.
* If the indicators are unlit, turning the knobs will not control any
parameters.
3. While playing the keyboard or pressing the pads to produce
sound, operate the REALTIME CONTROL knobs and
ASSIGNABLE SW buttons.
The sound will change according to the function assigned to
each knob or button.
Using Knobs or Buttons to
Modify the Sound (Realtime
Controller)
State of the controller settings
The controller applies to the part whose display is visible
Parameters that will change
when you turn a realtime controller knob
Parameters that will change when you press an assignable switch
Fantom-X678_r_e.book 124 ページ ２００５年５月１２日 木曜日 午後４時４０分