Applying effects in patch mode, Specifying how the sound will be output (routing), Signal flow diagram and parameters – Roland Fantom-X7 User Manual
Page 207: Output assign setting (p. 207), P. 207), 207 adding effects
207
Adding Effects
In Patch mode you can use two multi-effects (MFX1, MFX2), one
chorus, and one reverb. Multi-effect 1 (MFX1) will operate according
to the effect settings of the patch or rhythm set assigned to the
Keyboard part. Multi-effect 2 (MFX2) will operate according to the
effect settings of the patch or rhythm set assigned to the Pad part.
Chorus and reverb will both operate according to the settings of the
patch or rhythm set assigned to either the Keyboard part or the Pad
part.
Here you can make overall settings for effects, and the output
destination and level of each signal.
fig.22-004_50
For details on these settings, refer to
fig.22-005
Part Select
Select the part for which you want to make settings.
Value:
KBD, PAD
Tone Select
Select the tone for which you want to make settings.
Value:
1–4
*
This parameter is
Rhythm Key Select
when a rhythm set is being
selected. You can select the rhythm tone (A0–C8) for which you want
to make settings.
Patch Output Assign
Specifies how the direct sound of each patch will be output.
Value:
MFX:
Output in stereo through multi-effects. You can also
apply chorus or reverb to the sound that passes
through multi-effects.
A, B:
Output to the OUTPUT A (MIX) jack or OUTPUT B
jack in stereo without passing through multi-effects.
1–4:
Output to the INDIVIDUAL 1–4 jacks in mono
without passing through multi-effects.
TONE:
Outputs according to the settings for each tone.
If you've made settings so that sounds are separately routed to
the INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plug
is actually inserted in the INDIVIDUAL 2 jack, the sounds
routed to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixed
and output from the INDIVIDUAL 1 jack.
• This parameter is
Rhythm Output Assign
when a rhythm set is
being selected. You can specifies for each rhythm set how the
direct sound will be output.
If the Mix/Parallel parameter is set to “MIX,” all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 230).
Applying Effects in Patch
Mode
Specifying How the Sound Will Be
Output (Routing)
Signal Flow Diagram and
Parameters
1
6
5
4
2
3
7
12
16
14
15
17
18
8
11
13
10
9
19
20
1
1
2
Fantom-X678_r_e.book 207 ページ ２００５年５月１２日 木曜日 午後４時４０分