Roland Fantom-X7 - Manual (Page 165)

165
Playing Back a Song
4. Press [PLAY] to start Chain Play.
Starting from the song of step 1. If you want to stop playback
before it is finished, press [STOP].
If you want to begin playback from midway through the chain,
use
or to move to the desired step, and then press
[PLAY].
5. When you are finished with Chain Play, press [STOP].
Chain Play cannot be started or stopped by a Start or Stop
message from an external MIDI device. Nor will MIDI
Continue, Song Position Pointer, Song Select, or Clock messages
be received.
Fast-forward, rewind, and jump can be performed during playback,
as well as while stopped. Use the following procedures for each
operation.
Fast-forward: Press [FWD].
Continuous fast-forward: Press and hold [FWD].
Rapid fast-forward: Press [FWD] and then press [BWD].
Rewind: Press [BWD].
Continuous rewind: Press and hold [BWD].
Rapid rewind: Press [BWD] and then press [FWD].
Jump to the previous locate position:
Hold down [SHIFT] and press [BWD].
Jump to the next locate position:
Hold down [SHIFT] and press [FWD].
Jump to the beginning of the song:
Press [RESET].
A certain amount of time may be required for fast-forward,
rewind, or jump during Quick Play.
• Song playback will be interrupted if you jump to the beginning
or end of the song while the song is playing.
When you play back from the middle of a song, for example after
fast-forward or rewind, the correct patch may not be selected, or the
pitch may be incorrect. This is because the MIDI messages in the area
that you skipped have not been transmitted to the sound generator.
In such cases, you can use the
MIDI Update function. When you
perform MIDI Update , the MIDI messages (other than Note
messages) from the beginning of the song until the location to which
you moved will be transmitted to the sound generator, ensuring that
the sound generator will be in the correct state for the resumption of
playback.
1. Make sure that song playback is stopped.
It is not possible to perform MIDI Update while the song is
playing.
2. Hold down [SHIFT] and press [PLAY].
The display will indicate “MIDI Update...” while processing
takes place, and when finished, will indicate “Completed!”
If you want to silence the playback of a specific instrument, you can
mute the phrase track that contains the sequencer data for that
instrument.
For details on the procedure, refer to “Silencing the Playback
of a Track (Mute)” (p. 178)
Various Playback Methods
Fast-Forward and Rewind During
Playback
Playing Back Correctly from the
Middle of the Song (MIDI Update)
Muting the Playback of a Specific
Instrument
Fantom-X678_r_e.book 165 ページ ２００５年５月１２日 木曜日 午後４時４０分