Roland Fantom-X7 - Manual (Page 21)

21
Getting Ready
941 Once the connections have been completed (p. 19), turn on power to your various devices in
the order specified. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
fig.bender.e
1. Before turning on the Fantom’s power, consider these two questions:
• Are all peripheral devices connected correctly?
• Have the volume controls of the Fantom-X and all connected audio devices been
turned to their lowest settings?
2. Turn on the POWER ON switch located on the rear panel of the Fantom-X.
fig.02-003
942 * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power
up is required before the unit will operate normally.
3. Turn on the power for any connected amplifiers or speakers.
4. Play the Fantom-X’s keyboard, gradually increasing the setting of its volume control,
and then carefully raise the volume of your connected amplifiers or speakers to the
desired listening level.
fig.02-004
Turning On the Power
To ensure proper operation of
the pitch bend lever, make
sure not to touch the lever
when turning the Fantom-X’s
power on.
Do not touch!
Be careful not to set your
listening volume too high to
avoid damage to your amp/
speaker system or your
hearing.
Fantom-X678_r_e.book 21 ページ ２００５年５月１２日 木曜日 午後４時４０分