Roland Fantom-X7 - Manual (Page 244)

244
Expanding the Memory
The Fantom-X comes with 32 MB of memory into which audio
samples can be loaded. However, in some cases, 32 MB of memory
will be insufficient for loading large amounts of data. In such a case,
you will have to add separately sold memory (DIMM). Memory can
be expanded up to 64/128/256/512 MB.
Before expanding the memory, consult with your retailer, the nearest
Roland Service Center, or an authorized Roland distributor.
901 • To avoid the risk of damage to internal components that can be
caused by static electricity, please carefully observe the
following whenever you handle the board.
1 • Before you touch the board, always first grasp a metal object
(such as a water pipe), so you are sure that any static electricity
you might have been carrying has been discharged.
2 • When handling the board, grasp it only by its edges. Avoid
touching any of the electronic components or connectors.
5 • Save the bag in which the board was originally shipped, and
put the board back into it whenever you need to store or
transport it.
• Use a Phillips screwdriver that is suitable for the size of the
screw (a number 2 screwdriver, Fantom-X6/X7 only). If an
unsuitable screwdriver is used, the head of the screw may be
stripped.
• To remove a screw, rotate the screwdriver counter-clockwise.
To tighten the screws, rotate the screwdriver clockwise.
• Be careful that the screws you remove do not drop into the
interior of the Fantom-X.
• Be careful not to cut your hand on the edge of the cover or the
opening edge while removing the cover.
• Do not touch any of the printed circuit pathways or connection
terminals.
• Never use excessive force when installing a circuit board. If it doesn’t
fit properly on the first attempt, remove the board and try again.
• When circuit board installation is complete, double-check your
work.
• Always turn the unit off and unplug the power cord before
attempting installation of the memory DIMM board.
• Install only the specified memory DIMM board. Remove only
the specified screws.
• When turning the unit upside-down, get a bunch of newspapers
or magazines, and place them under the four corners or at both
ends to prevent damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or controls get
damaged.
• When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
• Do not leave the bottom cover removed. After installation of the
memory module is complete, be sure to replace the cover.
Install the memory module after removing the bottom panel cover.
1. Before expanding the memory, turn off the power of the
Fantom-X and all connected devices, and disconnect all
cables, including the Power cable, from the Fantom-X.
2. From the Fantom-X, remove only the screws shown in the
following diagram, and detach the cover. On the Fantom-
X6/X7, the cover is located on the bottom panel. On the
Fantom-X8, it is located on the front panel. From the
Fantom-X, remove only the screws shown in the following
diagram, and detach the cover.
* A hex wrench is included with the Fantom-X8. When removing
screws, you must use this hex wrench.
fig.30-002.e
fig.30-003.e
fig.31-002
3. Press outward the white clips at either end of the socket
should be in the downward position.
fig.31-003
Precautions for Expanding
Memory
tighten loosen
How to Expand the Memory
Screws to be removed
Fantom-X6/X7 : bottom
Clé hexagonale 5 mm
Fantom-X8 : Panneau avant
Vis à enlever
Fantom-X678_r_e.book 244 ページ ２００５年５月１２日 木曜日 午後４時４０分