Roland Fantom-X7 - Manual (Page 78)

78
Creating a Patch
Portamento Start
When another key is pressed during a pitch change produced by
portamento, a new pitch change will begin. This setting specifies the
pitch at which the change will begin.
Value
PITCH: Starts a new portamento when another key is
pressed while the pitch is changing.
fig.06-048.e
NOTE: Portamento will begin anew from the pitch where
the current change would end.
fig.06-049.e
Portamento Time
When portamento is used, this specifies the time over which the
pitch will change. Higher settings will cause the pitch change to the
next note to take more time.
Value: 0–127
fig.06-050_50
Tone Delay Mode
Selects the type of tone delay.
Value
NORM: The tone begins to play after the time specified in the
Delay Time parameter has elapsed.
fig.06-051.e
HOLD: Although the tone begins to play after the time
specified in the Delay Time parameter has elapsed, if
the key is released before the time specified in the
Delay Time parameter has elapsed, the tone is not
played.
fig.06-052.e
C5
D4
C4
press D4 key
Pitch
Time
press C4 key
press C5 key
C5
D4
C4
press D4 key
Pitch
Time
press C4 key
press C5 key
Miscellaneous Settings (Misc)
Note off
Delay time
Note on
No Tone Delay
Note off
Delay time
Note on
No sound
played
Fantom-X678_r_e.book 78 ページ ２００５年５月１２日 木曜日 午後４時４０分