Roland Fantom-X7 - Manual (Page 185)

185
Editing Songs
Status
Selects the type of data to be copied.
Value
ALL
NOTE
Poly Aftertouch
Control Change
Program Change
Channel Aftertouch
Pitch Bend
System Exclusive
Tune Request
Pattern Call
If the source track is set to “TEMPO,” the Status parameter will
not be available.
Range Min, Range Max
If you have selected “NOTE,” “P.AFT,” “C.C,” or “PROG” for the
Status parameter, specify the range. Set “Range Min” to the lowest
value of the range, and “Range Max” to the highest value of the
range.
To copy all notes or polyphonic aftertouch data, set “Range
Min” to “C-1” and “Range Max” to“G9.” To copy C4, set
“Range Min” and “Range Max” to “C4.” To copy C3 through
C4, set “Range Min” to “C3” and “Range Max” to “C4.”
• To copy all controller numbers, set “Range Min” to “0” and
“Range Max” to “127.” To copy all program numbers, set
“Range Min” to “1” and “Range Max” to “128.” To copy
number 4, set “Range Min” and “Range Max” to “4.” To copy
numbers 3 through 14, set “Range Min” to “3” and “Range
Max” to “14.”
This function inserts blank measures into a specified song position.
As you can set the time signature of the blank measures, this is
convenient when inserting a phrase having a different time signature
in the middle of a song.
fig.19-014_50
For details on the settings, refer to “Basic Operation for Track
Editing” (p. 180)
Track / Pattern (Source Track)
Specifies the track(s) or pattern into which blank measures will be
inserted.
Value
ALL: Phrase tracks 1–16, the beat track, and the tempo
track
TRK 1–TRK 16: The specified phrase track
TEMPO: Tempo track
PTN001–PTN100: The specified pattern
Measure, For (Edit Range)
Specifies the measure location at which the blank measures are to be
inserted, and the number of blank measures to be inserted.
Beat
In general, the time signature of the measure immediately before
insertion will be used for the blank measures. To change the time
signature of the blank measures to be inserted, use the Beat
parameter.
Beat can be specified only when you have set the Track
parameter to “ALL.”
This transposes the pitch of notes within a specified area, over a +/-
127 semitone range. Use this function to modulate from one key to
another in a song, or to transpose the entire song.
fig.19-015_50
For details on the settings, refer to “Basic Operation for Track
Editing” (p. 180)
Track / Pattern (Source Track)
Sets the phrase track(s) or pattern that is to be transposed.
Value
ALL: Phrase Tracks 1–16
TRK 1–TRK 16: The specified phrase track
PTN001–PTN100: The specified pattern
Ch / Part
Specifies the MIDI channel(s) of the notes to be transposed.
Set this parameter to “ALL” for transposing all notes. When
transposing only the notes of specific MIDI channel(s), select the
MIDI channel(s) using this parameter.
Value: ALL, Ch1–Ch16
Measure, For (Edit Range)
Sets the range of measures that are to be transposed. If you set “For”
to “ALL,” all measures will be specified.
Inserting a Blank Measure (Insert)
Transpose the Key (Transpose)
Fantom-X678_r_e.book 185 ページ ２００５年５月１２日 木曜日 午後４時４０分