Initializing performance settings (init), Operation (p. 119), 119 creating a performance – Roland Fantom-X7 User Manual
Page 119
119
Creating a Performance
Control D Beam (Control D Beam Switch)
Specifies whether each part will be controlled by the D Beam.
Value:
OFF, ON
Control Knob (Control Knob Switch)
Specifies whether each part will be controlled by the control knob.
Value:
OFF, ON
When using patches in Performance mode, some settings such as
effects settings will be affected by Performance settings. If you wish
to edit a patch while hearing how it will sound in the Performance,
use this procedure:
*
Here we explain how to change the setting of a patch assigned to a
part. The procedure for changing the settings of rhythm sets is the
same. Substitute “rhythm set” wherever “patch” appears in a
sentence.
1.
Make sure the Performance mode is selected.
2.
Press [PATCH EDIT].
The patch assigned to the part is displayed in the Patch Edit
screen.
fig.09-020_50
3.
The rest of the procedure is the same as when making
changes in Patch mode (p. 56).
“Initialize” means to return the settings of the currently selected
sound to a standard set of values.
The Initialize operation will affect only the currently selected
sound; the sounds that are stored in user memory will not be
affected. If you wish to restore all of the Fantom-X’s settings to
their factory values, perform a Factory Reset (p. 235).
1.
Select the Performance that you wish to initialize (p. 99).
2.
Hold down [SHIFT] and press [F1 (Init)].
The Performance Initialize window will appear.
3.
Turn the VALUE dial or press
or
to select the
initialization type.
•
DEFAULT:
Resets the currently selected performance
in the Temporary memory to the
standard values. Use this setting when
you wish to create a sound from scratch.
•
SOUND CONTROL:
Initializes the values of the following part
parameters. Cutoff Offset, Resonance
Offset, Attack Time Offset, Release Time
Offset, Decay Time Offset, Vibrato Rate,
Vibrato, Depth, Vibrato Delay
4.
Press [F8 (Select)].
A message will ask you for confirmation.
5.
Press [F8 (Exec)].
The initialization will be carried out, and you’ll be returned to
the previous screen.
To cancel, press [F7 (Cancel)].
Changing the Settings of the
Patch Assigned to a Part
Initializing Performance
Settings (Init)
Fantom-X678_r_e.book 119 ページ ２００５年５月１２日 木曜日 午後４時４０分