Roland Fantom-X7 - Manual (Page 213)

213
Adding Effects
Here we will explain how to make multi-effects settings in
Performance mode.
fig.22-008_50
Each time you press the [F3 (MFX1/2/3)] button, it will
alternate between 1, 2, and 3.
For details on these settings, refer to “Making Effect Settings”
(p. 206)
Type (Multi-Effects Type)
Use this parameter to select from among the 78 available multi-
effects. For details on multi-effects parameters, refer to
“Multi-
Effects Parameter” (p. 270).
Value: 00 THROUGH– 78 SYNPATHETHIC RESONANCE
In this setting screen, you can edit the parameters of
the multi-effects that is selected by the Multi-effects
Type setting. For details on the parameters that can
be edited, refer to
“Multi-Effects Parameter” (p.
270).
You can use the REALTIME CONTROL knobs to edit up to four
of the most important parameters, which have been pre-selected
for each type of multi-effect. The knobs shown in the screen
correspond to the Realtime Control knobs. When you enter the
MFX 1–3 screen, the indicator at the right of the Realtime
Control knobs will go out, and the Realtime Control knobs can
be used to edit the MFX parameters. If you once again press the
button located at the right of the Realtime Control knobs so the
indicator is lit, the knobs will control their original functions.
When you exit the MFX 1–3 screen, the indicator will
automatically return to its previous lit state.
Parameters marked by can be selected as a multi-effect
control destination parameter (p. 214).
In Patch mode, the Keyboard part can use MFX1 and the Pad
part can use MFX2.
fig.22-009_50
For details on these settings, refer to “Making Effect Settings”
(p. 206)
Source 1–4 (Multi-Effects Control Source 1–4)
Sets the MIDI message used to change the multi-effects parameter
with the multi-effects control.
Value
OFF: Multi-effects control will not be used.
CC01–31, 33–95: Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to
“MIDI Implementation” (p. 298).
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS CTRL1–SYS CTRL4: MIDI messages used as common multi-
effects controls.
If you want to use common controllers for the entire Fantom-X,
select “SYS CTRL 1”–”SYS CTRL 4.” MIDI messages used as
System Control 1–4 are set with the Sys Ctrl 1–4 Source
parameters (p. 233).
In patch/rhythm set mode, there are parameters that determine,
for each tone/rhythm tone, whether or not Pitch Bend,
Controller Number 11 (Expression) and Controller Number 64
(Hold 1) are received (p. 79). When these settings are “ON,” and
the MIDI messages are received, then when any change is made
in the settings of the desired parameter, the Pitch Bend,
Expression, and Hold1 settings also change simultaneously. If
you want to change the targeted parameters only, then set these
to “OFF.”
• There are parameters that determine whether or not specific
MIDI messages are received for each MIDI channel (p. 79).
When using the multi-effects control, confirm that any MIDI
messages used for the multi-effects control will be received. If
the Fantom-X is set up such that reception of MIDI messages is
disabled, then the multi-effects control will not function.
Making Multi-Effects
Settings (MFX1–3)
Making Multi-Effects
Settings (MFX Control)
Fantom-X678_r_e.book 213 ページ ２００５年５月１２日 木曜日 午後４時４０分