Unloading a sample (unload), Removing unwanted portions of a sample (truncate), 155 editing a sample – Roland Fantom-X7 User Manual
Page 155
155
Editing a Sample
6.
When you’ve finished setting the Original Key of all
samples, create the multisample as described in “Creating
a Multisample (Create Multisample)” (p. 153).
In the Sample Edit screen you can press [F1 (Unload)] to unload the
currently selected sample and return to the previous screen.
This operation cuts the portions of the sample that are earlier than
the Start Point and later than the Loop End Point.
*
You cannot execute this with more than one sample selected.
1.
Press [SAMPLE EDIT] to access the Sample Edit screen.
2.
Press
or
to select the parameter.
•
Start Point:
Specifies the sample start point.
•
End Point:
Specifies the sample end point.
3.
Either turn the VALUE dial or use [INC] [DEC] to set the
value.
4.
Press [F3 (Sample Modify)] to access the Sample Modify
window.
5.
Press [F1 (Truncate)].
fig.15-016_50
6.
If you want to replace the current sample with the truncated
sample, press [F6 (Over Write)] to display the “
✔
” symbol.
7.
Press [F8 (Exec)].
A message will ask you for confirmation.
8.
To execute the Truncate operation, press [F8 (Exec)].
*
If you want to cancel without executing, press [F7 (Cancel)].
In some cases, the audio quality will be improved if you boost the
high-frequency range of an imported sample. Also, the high-
frequency range of the sample may be emphasized when you use a
sampler made by another manufacturer. In this case, you can
minimize the change in tonal character by attenuating the high-
frequency range.
*
You cannot execute this with more than one sample selected.
1.
Press [SAMPLE EDIT] to access the Sample Edit screen.
2.
Press [F3 (Sample Modify)] to access the Sample Modify
window.
3.
Press [F2 (Emphasis)].
fig.15-017_50
4.
Either turn the VALUE dial or use [INC] [DEC] to select the
emphasis type.
•
PreEmphasis:
Emphasizes the high-frequency range.
•
DeEmphasis:
Attenuates the high-frequency range.
5.
If you want to replace the current sample with the
emphasized sample, press [F6 (Over Write)] to display the
“
✔
” symbol.
6.
Press [F8 (Exec)].
A message will ask you for confirmation.
7.
To execute, press [F8 (Exec)].
*
To cancel, press [F7 (Cancel)].
Unloading a Sample
(Unload)
Removing Unwanted
Portions of a Sample
(Truncate)
Boosting or Limiting the
High-frequency Range of
the Sample (Emphasis)
Fantom-X678_r_e.book 155 ページ ２００５年５月１２日 木曜日 午後４時４０分