Roland Fantom-X7 - Manual (Page 203)

203
Playing a Phrase at the Touch of a Finger (RPS Function)
The RPS (Realtime Phrase Sequence) function lets you assign
patterns to the keyboard or Pad, and play a pattern by pressing a
single note.
For example, a complex phrase that would be difficult to play live
can be assigned to a note of the keyboard, and played with one
finger at the appropriate moment.
Since up to eight patterns can be playing at once, you can create
patterns for separate instruments such as drums, bass, and
keyboard, and combine them to create a new song. This performance
can also be recorded, allowing you to use it in a way similar to
phrase sampling.
fig.21-001.e
Before you use the RPS function, you must record the desired phrase
in a pattern. For details on recording, refer to
“Recording Your
Performance as You Play It (Realtime Recording)” (p. 170) or
“Inputting Data One Step at a Time (Step Recording)” (p. 174).
Only note messages should be recorded in a pattern. If a large
amount of MIDI data is recorded in a pattern, using RPS to play
back the pattern can cause notes to be delayed. MIDI messages
other than note messages should be recorded in a phrase track.
You can assign a pattern to each note of the keyboard, and specify
how the pattern will be played. These settings are made
independently for each song, and will be saved when you save the
song in MRC Pro song format.
In order to make RPS settings, you must first load a song into
Temporary Area.
1. Holding down [SHIFT] and pressing [RPS].
The RPS Setup screen appears.
fig.21-002_50
In this screen you can set various parameters related to the RPS
function.
2. Use [CURSOR] to move the cursor to each parameter, and
turn the VALUE dial or press [INC]/[DEC] to make the
setting.
Pattern parameter, Playback Mode parameter, and Mute Group
parameter are set for each key. Although the Fantom-X6 has a
61-note keyboard and the Fantom-X7 has a 76-note keyboard,
you can also make settings for all keys in the range of E0 to G9.
Settings for the Trigger Quantize parameter and Velocity Sens
parameter are for the entire song.
• Trigger Quantize
This parameter specifies how pattern playback is to begin when
a key is pressed during song playback or recording.
Value
REAL: The pattern will begin playing at the moment
you press the key.
BEAT: If the song is being played or recorded, the
pattern will begin playing at the beginning of
the next beat if you press the key in the middle
of the beat.
MEASURE: If the song is being played or recorded, the
pattern will begin playing at the beginning of
the next measure if you press the key in the
middle of the measure.
Before You Use the RPS
Function
Record a Pattern
Phrase track 2
Phrase track 1
Phrase track 15
Phrase track 16
Pattern track
Pattern
99
Pattern
100
Song
Pattern
1
Pattern
2
Settings for the RPS Function
Fantom-X678_r_e.book 203 ページ ２００５年５月１２日 木曜日 午後４時４０分