Roland Fantom-X7 - Manual (Page 225)

225
Settings Common to All Modes (System Function)
Settings that affect the entire operating environment of the Fantom-
X, such as tuning and MIDI message reception, are referred to as
system functions. This section explains how to make settings for
the System functions and describes the functions of the different
System parameters.
1. Press [MENU] to open the Menu window.
2. Press or to select “System,” and then press
[ENTER].
The System Setup screen appears.
fig.25-001_50
3. Press Function button [F3], [F4] to select the tab of the edit
group.
• [F3 (Setup)]
Set system parameters (p. 226).
• [F4 (Info)]
View system information (p. 234).
4. The parameters are organized into several edit groups. Use
[F1 (
⇑ )][F2 ( ⇓ )] to switch tabs.
5. Use [CURSOR] to move the cursor to the parameter you
wish to modify.
When the cursor is located at a parameter value, you can press
[ENTER] to access a window for setting the value.
• When all the parameters cannot be shown within a single
settings screen, a scroll bar will be displayed at the right side of
the screen. In such cases, press
to scroll the screen
downward.
6. Turn the VALUE dial or press [INC]/[DEC] to get the value
you want.
7. Repeat steps 4–6 to set each System parameter you want to
edit.
8. To save the settings you modified, press [F8 (System
Write)] and perform the Write operation. If you do not want
to save, press [EXIT] to return to the previous screen.
Changes you make to the System function settings are only
temporary—they will be discarded as soon as the power is turned
off. If you want to keep any changes you’ve made in the system
settings, you must save them in internal system memory.
When you perform the save procedure, the data that previously
occupied the save destination will be lost. However, the factory
setting data can be recovered by performing the Factory Reset
procedure.
1. Change the system function settings, and press [F8
(System Write)].
fig.25-002_50
The display will indicate “System Write Completed!” The data
will be saved, and you’re returned to the System Setup screen.
How to Make System
Function Settings
Saving the System Settings
(System Write)
Fantom-X678_r_e.book 225 ページ ２００５年５月１２日 木曜日 午後４時４０分