ABAQUS Volume II: I–Z - Manual (Page 100)

*JOINT ELASTICITY
5. Temperature.
6. First field variable.
7. Second field variable.
8. Third field variable.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than three):
1. Fourth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define the elastic behavior as a function of
temperature and other predefined field variables.
Data lines for MODULI=SPUD CAN and NDIM=3:
First line:
1. , equivalent elastic shear modulus for vertical displacements.
2. , equivalent elastic shear modulus for horizontal displacements.
3. , equivalent elastic shear modulus for rotational displacements.
4. , Poisson’s ratio of the soil.
5. , torsional elastic modulus.
6. Temperature.
7. First field variable.
8. Second field variable.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than two):
1. Third field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define the elastic behavior as a function of
temperature and other predefined field variables.
Data lines for MODULI=GENERAL and NDIM=2:
First line:
1. .
2. .
3. .
4. .
5. .
6. .
10.2–2
ABAQUS Version 6.1 Module: ID:
Printed on: