ABAQUS Volume II: I–Z - Manual (Page 432)

*SLIDE LINE
SMOOTH
Set this parameter equal to the smoothing fraction, f, to round discontinuities between line segments
of a slide line. The default is 0. The limit is
.
Data lines if the GENERATE parameter is omitted:
First line:
1. First node number on this slide line.
2. Second node number on this slide line.
3. Third node number on this slide line.
4. Etc.
Repeat this data line as often as necessary to specify the nodes forming the slide line. Enter up to 16
integer values per line.
Data lines if the GENERATE parameter is included:
First line:
1. First node number of the series.
2. Last node number of the series.
3. Increment between node numbers.
Repeat this data line as often as necessary to specify the nodes forming the slide line.
18.19–2
ABAQUS Version 6.1 Module: ID:
Printed on: