ABAQUS Volume II: I–Z - Manual (Page 277)

*PLASTIC
Data lines for HARDENING=COMBINED with DATA TYPE=STABILIZED:
First line:
1. Yield stress.
2. Plastic strain.
3. Strain range.
4. Temperature.
5. First field variable.
6. Second field variable.
7. Etc., up to four field variables.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than four):
1. Fifth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define the dependence of yield stress on plastic
strain and, if needed, on strain range, temperature, and other predefined field variables.
Data lines for HARDENING=COMBINED with DATA TYPE=PARAMETERS:
First line:
1. Yield stress at zero plastic strain.
2. Kinematic hardening parameter, C.
3. Kinematic hardening parameter, .
4. Temperature.
5. First field variable.
6. Second field variable.
7. Etc., up to four field variables.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than four):
1. Fifth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define the dependence of yield stress and
kinematic hardening parameter
C on temperature and other predefined field variables. cannot depend
on temperature and predefined field variables.
Data lines for HARDENING=KINEMATIC:
First line:
1. Yield stress.
16.12–3
ABAQUS Version 6.1 Module: ID:
Printed on: