ABAQUS Volume II: I–Z - Manual (Page 177)

*MULLINS EFFECT
Data lines to define the material constants if both the TEST DATA INPUT and USER parameters
are omitted:
First line:
1. .
2. .
3. (If this entry is left blank, the default value is taken to be 0.0 in ABAQUS/Standard and 0.1
in ABAQUS/Explicit.)
4. Temperature.
5. First field variable.
6. Etc., up to four field variables.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than four):
1. Fifth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define the material constants as a function of
temperature and other predefined field variables.
Data lines to define the material properties if the USER parameter is specified:
No data lines are needed if the PROPERTIES parameter is omitted or set to 0. Otherwise, first line:
1. Material properties, eight per line.
Repeat this data line as often as necessary to define the material properties.
13.23–3
ABAQUS Version 6.1 Module: ID:
Printed on: