ABAQUS Volume II: I–Z - Manual (Page 419)

*SHELL GENERAL SECTION
3. , temperature for these values of Y and .
4. First field variable.
5. Second field variable.
6. Etc., up to five field variables.
Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than five):
1. Sixth field variable.
2. Etc., up to eight field variables per line.
Repeat this set of data lines as often as necessary to define Y and as functions of temperature and
other predefined field variables.
Data lines if the USER parameter is included:
First line:
1. Shell thickness. This value is ignored if the NODAL THICKNESS parameter is included.
Second line:
1. Enter the data to be used as properties in user subroutine UGENS. Enter all floating point values
first, followed immediately by the integer values.
Repeat this data line as often as necessary to define the properties required in UGENS. Enter eight values
per line for both real and integer values.
18.14–5
ABAQUS Version 6.1 Module: ID:
Printed on: